![]() STEP 13: Use a C-clip tool to remove the c-lip. STEP 12: Use (2) 12MM wrenches to remove the bolt that attaches the shifter to the main linkage. ![]() STEP 11: Pull down to remove the reverse lockout cable from the shifter. You can now lift up and remove the rubber shifter boot STEP 9: Remove the (2x) Plastic screws that hold the rubber boot in place. You can now lift off and remove the reverse lockout lever and spring from the shifter. This will release the reverse lockout cable. ![]() STEP 8: Use a punch and small hammer tap out the roll pin. You will also need to undo the electrical connection on the underside of the trim. STEP 6: Pull back on the front portion of the center console trim to free it from the plastic clips. STEP 5: With the center console now loose, slide it back out of the way. STEP 4: Engage the e-brake and lift up on the boot to expose the (1x) Phillips Head Screw. STEP 2: Remove the small carpet liner from inside of the center console compartment to reveal the (2x) Phillip/10mm screws. Do not lift up on the reverse lockout while you have this linkage locked. You will need to line up the two holes and insert either a small Allen key, screw or nail to stop the reverse lockout linkage from moving during installation. STEP 1: Securely lift the car and locate this reverse linkage on the driver side of the transmission. Order own Agency Power 6-Speed Short Shifter by CLICKING HERE This guide is to help with the installation of the Agency Power 6-Speed Short Shifter Subaru STI 2004-2017
0 Comments
Leave a Reply. |